Friction adjustment - rubber nub

I have been contacted by a few customers that have noted that the friction in the clip magnetic joint is slightly different between the clips in their omnifixo kits.
I don't know how common this issue is but to be sure you have the best possible experience I want to highlight a solution to this.

In the center hole of the magnet there is a small black TPU/rubber nub. The idea and purpose of this rubber nub is to create just a little bit of extra friction to the joint.

Now it seems like some magnetic feets have this "rubber nub" inserted a bit too far.

Luckily this is easy to adjust, just gently push a non sharp, non magnetic pin (like a matchstick) from the underside of the center hole of the magnet feet, towards the ball until the friction in the joint feels "right".

 

 

1 comment

John

Cool looking product. Here’s a suggestion, place an “Email me when back in stock” on your home page or product selection pages. While I’m at it, Email me when back in stock please.

Leave a comment

Please note, comments must be approved before they are published