Friction adjustment - rubber nub

Some magnetic feet have the "rubber nub" inserted a little bit too far.

To adjust, push a non magnetic pin, like a matchstick, from the underside of the center hole of the magnet feet. The idea and purpose of the rubber nub is to create just a little bit of extra friction to the joint, but it should not lift the ball from the magnet.


1 comment


Cool looking product. Here’s a suggestion, place an “Email me when back in stock” on your home page or product selection pages. While I’m at it, Email me when back in stock please.

Leave a comment

Please note, comments must be approved before they are published